If you'd like to reconnect PM5 to the host device most recently connected, you can refer to this article.
You can reconnect PM5 by pressing button combination or QR code.
Before Start
- Reconnection is available for SPP and HID mode. (Unavailable for HID LE mode)
- The PM5 and the host device must be connected at least one or more times after the factory reset.
APPLIES TO
PM5
- by Button Combination: 92.06 (Feb 07 2022) and later
- by QR Code: 92.08 (Nov 24 2023) and later
Reconnect by Button Combination
Supporting firmware version: Available from 92.06 (Feb 07 2022).
- While pressing reset button on PM5, press and hold the scan button on trigger accessory.
- Release the buttons when blinking green LED.
- Press shortly the scan button on trigger accessory.
Note:
- Do 2~3 steps within 5 seconds after blinking green LED.
- If no device information is connected before, PM5 emits a long beep sound and red LED blinks three times.
Reconnect by QR Code
Supporting firmware version: Available from 92.08 (Nov 24 2023).
Scan the following QR Code.
