Point Mobile's RFID reader can connect with the host device in 2 ways, Bluetooth and Wired.
All RFID readers can use Bluetooth connection, in contrast, some RFID reader doesn't support the wired connection.
If you want to connect the reader via wired way, check the supporting models and how to connect in this article.
For wired connection, the RFID reader and host device must be assembled physically as the connection uses pogo pins of the device and reader.
Therefore, wired connection is only available with a certain host device-RFID reader combination. Refer to the table below.
Host Device | RFID Reader |
---|---|
PM30 | RF300 |
PM75 | RF750 |
PM90 | RF900 |
ex) If you are using PM30, you must use RF300 for wired connection.
|
In one of the following cases, wired connection will be closed.
On RFIDControl |
|
---|---|
On Device / Reader |
|
Auto-reconnect is performed when host device and RFID reader, connected through wired connection once, are re-installed,
or the host device wakes up from suspend mode while installed on RFID reader.
For auto-reconnect, ALL of the following states must be satisfied.
Previous connection is disconnected by removing host device from RFID reader
If you disconnected it by Connect to RFID Reader switch, auto-reconnect does not perform. |