Page History
ISSUE
- Failed to turn on device
- Device does not
...
RESOLUTION
First, try holding down POWER button for 12 seconds. This usually reboots the device.
- First of all, check if battery is fully discharged. To check this, plug AC/DC power source or place device to cradle. If power source apply properly,
| Note | ||
|---|---|---|
| ||
해결책에 관련하여 알아두어야할 내용이 있으면 여기에 작성 |
Related articles are here.
- start
APPLIES TO
| Page properties | ||
|---|---|---|
| ||
|
All Point Mobile devices
Troubleshooting Steps
| Cause | Solution | |
|---|---|---|
| 1 | Low battery | Charge device Check if the LED blinks five times in red when you tried to turn on the device, it indicates the battery is too low to turn on the device. Charge the device using a power adapter or charging cradle first. |
| 2 | Battery is not installed properly | Reinstall the battery Remove and install the battery again referring to the user manual. |
| 3 | Device freezes temporarily | Reset Power To reset the device power, perform one of the following ways. A. Press and hold the power button for 12 seconds. B. Press Reset hole (Only for PM70, PM80, PM66, PM85, PM90, PM75) When the device vibrates, release the button. The device will boot automatically. |
| 4 | System issue | Perform factory reset Find the right model from the How to Factory Reset, and perform a factory reset. |
| 5 | Repair or analysis required | Contact local reseller If you cannot solve the problem with the above steps, contact your local reseller to proceed repair or analyze the issue. |
Not Resolved?
Refer to similar troubleshooting guides.
| Content by Label | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
| title | RELATED ARTICLES |
|---|
...
|
