Page History
Among the various RFID readers released by Point Mobile, the readers that 's RFID reader can connect to with the host device with Wired connection are as follows. (The list will be updated continuously).
- RF300
- RF750
- RF900
...
type | note |
---|
in 2 ways, Bluetooth and Wired.
All RFID readers can use Bluetooth connection, in contrast, some RFID reader doesn't support the wired connection.
If you want to connect the reader via wired way, check the supporting models and how to connect in this article.
...
RFID Reader Supporting Wired Connection
...
For wired connection, the RFID reader and host device must be assembled physically as the connection uses pogo pins of the devicesdevice and reader.
Therefore, wired connection is only available with a certain host device-RFID reader combination. Refer to the table below.
Host Device | RFID Reader |
---|---|
PM30 | RF300 |
PM75 | RF750 |
PM90 | RF900 |
...
ex) If you are using PM30, you must use RF300 for wired connection.
...
How to Make Wired Connection
UI Steps | |||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||||
|
...
Disconnection
In one of the following cases, wired connection will be closed.
On RFIDControl |
|
---|---|
On Device / Reader |
|
Auto reconnect
Auto-reconnect is performed when host device and RFID reader, connected through wired connection once, are re-installed,
or the host device wakes up from suspend mode while installed on RFID reader.
For auto-reconnect, ALL of the following states must be satisfied.
- Devices connected through wired at least one time
- Open option and connect mode of RFID reader is set as Wired
Previous connection is disconnected by removing host device from RFID reader
UI Text Box If you disconnected it by Connect to RFID Reader switch, auto-reconnect does not perform.
- RFID reader and host device are turned on
...
Info | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|