To connect PM90 with RF88 as a wire connection, refer to this article.


APPLIES TO

  • RF88 main F/W: 98.01 (Jun 20 2024) and later versions
  • PM90
  • RFIDControl (V2): v1.0.12 and later versions


Installing PM90

Caution

  • PM90 MSR SKU cannot be installed onto the RF88.
  • Remove the hand strap of the device before installing it onto the RF88.
  1. Align the sled bracket of the RF88 to match the button holes to the PM90 buttons.
  2. Place the one side of the PM90 to the bracket first.
  3. Push the other side to engage the devices firmly.



Changing RF88 Connect Mode

When a PM90-exclusive sled bracket is assembled onto the RF88, you must set up the RF88's connection mode first.

This instruction is only for RF88 with PM90 sled bracket assembled.

With other sled brackets, the connect mode is not applicable.


To change the connection mode, press the mode button twice quickly.



Identifying Connect Mode

Depending on the connection mode, the Power or Bluetooth LED turns on.

To connect the RF88 with a PM90, check if the LED is turned on according to the mode you want first.

The connection mode will be maintains even after rebooting the RF88.

Status DescriptionLEDBeep
Bluetooth connection mode(Bluetooth LED) Blue blinking

(Once when changing) Short high

Wired connection mode

(Power) Turn on depending on the battery level

  • Green: 50~100%
  • Amber: 16~49%
  • Red: ~15%

(Once when changing) Short high

*Default = Bluetooth mode




RELATED ARTICLES